How to Run a Test Using the Hitron DSS01 Coax Cable Tester: Step-by-Step Guide

DSS-01 Installation Guide/How to Run a Test

How to Run a Test

To check the presence of a valid Internet signal at a coax outlet:

STEP 1 Slide the Power switch to ON

STEP 2 Connect the DSS-01 to the coax outlet.
STEP 3 Press the button.
STEP 4 Check the LED light:
Solid GREEN indicates that a valid Internet signal was detected and the coax outlet is ready for a cable modem.

Solid RED indicates that no Internet signal was detected.

Please Note: The DSS01 detects Broadband Internet signals over coax wiring within a set range of frequencies. The DSS01 does NOT detect MoCA signals which operate at a different frequency range.

    To start please register your product here.

      • Related Articles

      • DSS-01 User Manual

        Welcome to the DSS01 Digital User Manual, designed to be your comprehensive guide to the DSS01 Coax Cable Tester. Within each section, you'll find direct web links to online articles, providing you with instant access to the most current and relevant ...

      • HTEM4 Quick Install Guide

        Click here to view the Quick Install Guide for the HT-EM4 MoCA 2.5 Network Adapter

      • Is the DSS-01 a one-person test?

        Yes. The DSS-01 is small and compact to fit easily into your hand for one-person testing in very tight areas, without any problems.

      • How do you use the DSS-01?

        The DSS-01 connects to a coax cable or coax outlet by pushing on the F-connector and pressing one button to test the connection for valid signals from your Cable Broadband provider.

      • Will the DSS-01 be able to detect through a splitter?

        Yes. The DSS-01 tests and detects a specific range of signals and does not test for voltage.